[WANTED] 1963-1965 dart trunnion driveshaft

Cars and Mopar Parts Wanted

Thread Status:
Not open for further replies.
  1. barbee6043

    barbee6043 barbee 6043 FABO Gold Member

    Messages:
    11,560
    Likes Received:
    4273
    Joined:
    Jul 20, 2008
    Location:
    Shepherd, Texas ( SE Tx)
    Local Time:
    1:03 AM
    Contact Seller
    need one with a GOOD TRUNNION, FOR 63-5 DART. GOING IN 63 DART.

    located s w Missouri 65752. thanks
     
  2. azmopar

    azmopar rust free parts guy

    Messages:
    3,004
    Likes Received:
    85
    Joined:
    Feb 17, 2008
    Location:
    goodyear az
    Local Time:
    12:03 AM
    should have one ill check in a fw minutes 65 dart
     
  3. 64DartGTinAZ

    64DartGTinAZ FABO Gold Member FABO Gold Member

    Messages:
    2,523
    Likes Received:
    652
    Joined:
    Aug 14, 2010
    Location:
    Phoenix
    Local Time:
    12:03 AM
    I've got one, too, if azmopar doesn't have one

    (no idea best way to ship, but happy to try if you can suggest)
     
  4. azmopar

    azmopar rust free parts guy

    Messages:
    3,004
    Likes Received:
    85
    Joined:
    Feb 17, 2008
    Location:
    goodyear az
    Local Time:
    12:03 AM

    have one ball and trunion is nice and tight boot is torn though i can ship too:burnout:
     
  5. damraider

    damraider Well-Known Member

    Messages:
    1,131
    Likes Received:
    53
    Joined:
    Aug 29, 2007
    Location:
    San Ramon , Ca
    Local Time:
    11:03 PM
    why not just convert to a regular u-joint with a bolt on flange . Any drive shaft place can do it pretty cheap .
     
  6. barbee6043

    barbee6043 barbee 6043 FABO Gold Member

    Messages:
    11,560
    Likes Received:
    4273
    Joined:
    Jul 20, 2008
    Location:
    Shepherd, Texas ( SE Tx)
    Local Time:
    1:03 AM
    I have several cars I've been piecing back together from rollers. 3 slants and 2 S B. I intend to have the conversion deal done on the S B cars but would like to just use the trunnion for the slants. and yes I realize the trunnion in GOOD condition holds up under the max wedge., no problem.

    cost of a new shaft with the good spicer parts is $325. not a small investment for old fart like me!
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalize content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.