[Found!] 1966 Barracuda Right front fender patch and trim

[Tim Nelms]

I need the front portion of the right front fender and fender trim. you can see the portion that a prior owner trimmed off.

I will take a complete fender.

 

[Michael Brisebois]

One year fender...
You might need to get one from a "bone yard". I don't know if there are many in Georgia, there are a few out this way.

I scope these out because I have one also, but you might be able to "fab" a patch panel.

This was one of Plymouth's most unappreciated creations, with almost NO re-pop'd resto parts.
I love mine...a real fun ride.

 

[memike]

I just had to cut the good lower fenders on my 66, and tack them on , if you would like pictures and measurements let me know.
Good luck

 

[Tim Nelms]

One year fender...
You might need to get one from a "bone yard". I don't know if there are many in Georgia, there are a few out this way.

I scope these out because I have one also, but you might be able to "fab" a patch panel.

This was one of Plymouth's most unappreciated creations, with almost NO re-pop'd resto parts.
I love mine...a real fun ride.

Unfortunately there are few places with older cars in my area and none have a 66 Barracuda.

 

[Tim Nelms]

I just had to cut the good lower fenders on my 66, and tack them on , if you would like pictures and measurements let me know.
Good luck

View attachment 1715876120

I would appreciate pictures and measurements. If nothing else I will have references for a fabricator to make a patch.

 

[memike]

I would appreciate pictures and measurements. If nothing else I will have references for a fabricator to make a patch.

Be glad to, we have a nasty ice storm on me here in northeast Arkansas, it may be tomorrow before I get that done for you.

Happy to be of help

 

[memike]

I would appreciate pictures and measurements. If nothing else I will have references for a fabricator to make a patch.

Now then, first let me say I am not a draftsman.
These are the measurements that stood get you very close if not right on.
Done my best, cold shop

 

[memike]

If I can help with anything else let me now, I don't mind at all

 

[Tim Nelms]

Thank You so very much. I believe between the measurements and pictures I can have the missing pieces can be fabricated. Im still hopeful that someone has a decent patch because I lack good fabrication skills with compound curves.