[SOLD] 1967-1976 Clutch Z-Bar, REBUILT O.E.M.
- Thread starter BLKNBLU340DSTR
- Start date
-
- Status
RICK LAVERGNE
Active Member
HI CAN IT BE USED IN A BIG BLOCK CAR 1968 DART GST
Rick, personally, I would get the correct one, they are available. Likely going to run you around $150 bucks for everything. They do re-pop all of the Z-bar versions, I have seen them recently on e-bay,like Mopar had manufactured, but they do not come with the inside ball/pivot/seal components, sold separately for even more $$. Those ball/pivot/seal 'kits' usually run around $60. On the flip side of that, I have fabricated parts for decades. A lot can be done with a die grinder/torch/welder. I'm sure you will do the right thing.
Hey Rick, found this link for you. It is possible you may have to engineer one. Check these guys out on e-bay.New 1970 To 1974 Mopar E Body Big Block ONLY Clutch Linkage Torque Shaft Kit | eBay
RICK LAVERGNE
Active Member
OK THANK FOR INFO
- Status
-
