bc67barracuda
1967 Barracuda - Fastback
For the 1967 Barracuda there are 7 moulding holes on the upper & lower area of the trunk. But for the clips they give you 6 per moulding? Are there different clips for the ends?
1967 Barracuda Trunk Trim Mldg Clips
- Thread starter bc67barracuda
- Start date
-
cudacrazy67
Well-Known Member
Yes the 4 on the ends are studs with nuts on the backside.
bc67barracuda
1967 Barracuda - Fastback
Okay..thanks I gather those are the T-bolts?
cudacrazy67
Well-Known Member
Yeper
Factory used a slightly different stud on the ends and a closed nut. I suppose this could have been for safety since exposed bolt ends aren't friendly The longer studs on the lower trim would dig into the body too.
The same type T bolts you have can be used on the ends but they will need to be shortened. Those you have are what 3/4 inch ? I think a 1/2 inch length worked with the nuts I used. I had black plastic closed nuts here but have no idea where to buy more. Hope this helps
The same type T bolts you have can be used on the ends but they will need to be shortened. Those you have are what 3/4 inch ? I think a 1/2 inch length worked with the nuts I used. I had black plastic closed nuts here but have no idea where to buy more. Hope this helps
bc67barracuda
1967 Barracuda - Fastback
Thanks for your help!
-
