1967 GT Vert
Well-Known Member
So I am ready to sell my Dart GT Convertible. Had it 14 years and have done a lot to it.
1967 Dodge Dart GT Convertible
Original Slant 6- Now 1996 5.2 Magnum
Engine (Installed in 2024)
New Crank and Match Bearing Set- Balanced
(Crank can take a manual transmission)
Flat top pistons
New Freeze Out Plugs
Cam bearings and Mild COMP Cam (20-745-9)
New Roller Lifters, Pushrods, guides & 1.6 rockers
Valves done
Double Valve Springs
Heads resurfaced from 63cc to 58cc on each cylinder
New oil pan
MLS Head gasket set with ARP head bolts
Double roller timing chain with 3.9 Magnum engine tensioner
Melling high volume oil pump
Speed Master High Rise Intake
One Wire alternator
Aces EFI Top End Kit (Aces Distributor)
TTI Full Exhaust- polished ceramic coating
New EFI fuel tank and lines
Transmission
904 rebuilt 2024 with mild B&M shift kit
Deep pan
Torque Converter rebuilt
What else has been done?
Interior re-done with new carpet (floor patched)
New power top motor, hydraulic pistons & lines
Power windows
Front disc brakes/master cylinder
Aluminum radiator
LED head lights
Radio and in dash speaker installed
Front end was all rebuilt < 12 years ago
New dash circuit board
New trunk seal
What needs to be done?
It is a driver, so body can use work
Rear end is still 7 ¼ but working well
New top will be needed in a couple of years
1967 Dodge Dart GT Convertible
Original Slant 6- Now 1996 5.2 Magnum
Engine (Installed in 2024)
New Crank and Match Bearing Set- Balanced
(Crank can take a manual transmission)
Flat top pistons
New Freeze Out Plugs
Cam bearings and Mild COMP Cam (20-745-9)
New Roller Lifters, Pushrods, guides & 1.6 rockers
Valves done
Double Valve Springs
Heads resurfaced from 63cc to 58cc on each cylinder
New oil pan
MLS Head gasket set with ARP head bolts
Double roller timing chain with 3.9 Magnum engine tensioner
Melling high volume oil pump
Speed Master High Rise Intake
One Wire alternator
Aces EFI Top End Kit (Aces Distributor)
TTI Full Exhaust- polished ceramic coating
New EFI fuel tank and lines
Transmission
904 rebuilt 2024 with mild B&M shift kit
Deep pan
Torque Converter rebuilt
What else has been done?
Interior re-done with new carpet (floor patched)
New power top motor, hydraulic pistons & lines
Power windows
Front disc brakes/master cylinder
Aluminum radiator
LED head lights
Radio and in dash speaker installed
Front end was all rebuilt < 12 years ago
New dash circuit board
New trunk seal
What needs to be done?
It is a driver, so body can use work
Rear end is still 7 ¼ but working well
New top will be needed in a couple of years
