[SOLD] 1969 340 unassembled Short Block 372 Cubic Inch

[Moparturbo]

I have a .020 over machined 1969 340 block that comes with reconditioned rods, New Scat Cast crank with 3.58 stroke for the 340 mains, New TRW L2405F60 forged pistons to make it a 372.
I live outside of Zanesville Ohio. You can pick up in person or I will ship on your dime based on shipping quotes we go over. I am asking 2500.00. Pictures attached. Thanks

 

[A56]

Perhaps you could show a better picture of the vin on the pan rail? Some here still looking for their motor.

 

[HemiSSDart]

Perhaps you could show a better picture of the vin on the pan rail? Some here still looking for their motor.

Yes please!

 

[Moparturbo]

Perhaps you could show a better picture of the vin on the pan rail? Some here still looking for their motor.

I'll be at the garage tomorrow. I will get it posted.

 

[RustyRatRod]

@Garrett Ellison

 

[PROSTOCKTOM]

You say the block is .030" over? A 340 has a stock bore of 4.04", plus the .030" overbore that equals 4.070"

How are .060" over 4.00" 360 pistons going to work out at out 4.060" in a 4.070" bore?

Tom

 

[RustyRatRod]

You say the block is .030" over? A 340 has a stock bore of 4.04" bore plus the .030" overbore. That equals 4.070"

How are .060" over pistons going to work at 4.060" or 4.100"?

Tom

uhh.....with some blowby?

 

[cpearce]

Following

 

[dowboy1970]

You will not get blowby if the pistons won't fit the hole to begin with.

 

[RustyRatRod]

You will not get blowby if the pistons won't fit the hole to begin with.

Block is 4.070 according to the op. Pistons are .060 over 360 pistons. Bore is bigger than the pistons.

 

[dowboy1970]

I missed it being 360 pistons.

Sorry there, thought we were talking 340 stuff.

Did the 360 pistons come from the part #s?

I did not look that up.

I see it now.

 

[Moparturbo]

You say the block is .030" over? A 340 has a stock bore of 4.04", plus the .030" overbore that equals 4.070"

How are .060" over 4.00" 360 pistons going to work out at out 4.060" in a 4.070" bore?

Tom

Thanks for catching that. I was asleep at the wheel on that one. No idea why I was thinking that. Post is fixed

 

[Moparturbo]

Perhaps you could show a better picture of the vin on the pan rail? Some here still looking for their motor.

Done

 

[Moparturbo]

uhh.....with some blowby?

Listing fixed lol

 

[RustyRatRod]

@Garrett Ellison

 

[3forty]

@tandart66