Ironmike
Well-Known Member
Have a full set of all the above that came off some heads I ran into. They had somewhere between 5 and 800 miles on them. Were run with a Comp XE274 H cam.
The intakes have a part number 27017, they are 2.02, stainless and have a nice undercut.
Exhaust are 1.6, part number 27047, undercut and stainless also. Don't know who made the valves.
Springs are unmarked but believe they are Edelbrock part number 5767H. Retainers shims and locks all included.
Pretty sure this is the factory stuff that Eddy uses on their assembled heads. Good for .600 lift max.
All is nice stuff will need cleaned up
I cleaned 1 intake for picture purpose. Will ship the rest as is (kinda dirty).
I'll ship anywhere in the US Priority Mail for $165. MONEY ORDER preferred. Personal check ok.
Thanks for looking!
The intakes have a part number 27017, they are 2.02, stainless and have a nice undercut.
Exhaust are 1.6, part number 27047, undercut and stainless also. Don't know who made the valves.
Springs are unmarked but believe they are Edelbrock part number 5767H. Retainers shims and locks all included.
Pretty sure this is the factory stuff that Eddy uses on their assembled heads. Good for .600 lift max.
All is nice stuff will need cleaned up
I cleaned 1 intake for picture purpose. Will ship the rest as is (kinda dirty).
I'll ship anywhere in the US Priority Mail for $165. MONEY ORDER preferred. Personal check ok.
Thanks for looking!
Last edited:
