273 manifolds - SB pulleys - moore

[swing69]

1) Looking for set of 273 OEM manifolds. shipping to NJ. Nothing broken please, but bad flapper OK.

2) set of 3 SB pulleys: crank, WP and Alt., no AC or PS. With Alt brackets if possible.

 

[68 bee]

PM sent

 

[wyoduster]

Like this? Offer?

 

[packers6947]

1) Looking for set of 273 OEM manifolds. shipping to NJ. Nothing broken please, but bad flapper OK.

2) set of 3 SB pulleys: crank, WP and Alt., no AC or PS. With Alt brackets if possible.

i will sell for 60 shipped let me know thanks
joe

 

[TNT440_Cbody]

I can pick the pulleys up at the pick-a-part today if you want, off that '66 Barracuda I mentioned in my other thread you responded to. Yours for cost plus enough for me to buy lunch and shipping. :-D Will send you a PM with my phone #.

It shouldn't be more than $10-14 for the alt. bracket and I have no idea how much pulleys will cost.

Alternator was gone though, so the Alt. pulley will not be available.

 

[dodgedifferent2]

I also have a set i pulled from a dart
http://chatham-kent.kijiji.ca/c-car...s-exhaust-manifold-273-318-W0QQAdIdZ224214324
http://chatham-kent.kijiji.ca/c-car...s-exhaust-manifold-273-318-W0QQAdIdZ224212896

 

[swing69]

Those pictures of manifolds are for 67 and up (at least the drivers side is). the pass. side is the same though. Here is a pict of the manifolds that I need. They are pre-67, 273 only.

Pulley set: I should clarify; I need an alum. waterpump set, which will be different than the steel waterpump set on 273 and early 318LA motors.

 

[dodgedifferent2]

oops i had to edit mine i posted the same one twice.

 

[swing69]

I could use either or both pulley sets:

If a 273 steel waterpump, I need the crank pulley, waterpump pulley, bolt on timing tab, and alt. brackets, including the small offset head bracket.

If a later alum. pump 318: I need the alt bracket (no head bracket), crank and waterpump pulley - no bolt on timing mark, mark cast into alloy timing cover.

I'm only interested in complete sets, single pulley NO AC or PS cars please. thanks!!!!!!!

 

[cosgig]

Well, if the manifolds listed above aren't the ones you're looking for, I have a set removed from a 66 cuda. I personally removed them myself. I am asking $75.00 plus shipping, or $100.00 blasted and painted with high heat cast iron grey paint. Let me know if you need them, Geof

 

[swing69]

Update: I now have the 273 pulleys and manifolds.

Still could use a 71 (?) and later, small block, single groove crank pulley, WP pulley (alloy WP) and alt. brackets set. Yes, all is available repop....but good used are fine.

Thanks
Mike