[Found!] 318 4 barrel throttle cable/kickdown bracket.

[C2ndLTpigeon]

Hello,

Im looking for a bracket to raise the throttle cable and kick down so that I will reach the 4 barrel edlebrock AVS carb I installed. If anyone has one for sale or know of anyone the sells an aftermarket one would be much appreciated. I hope this is the only thing I need but am new to this linkage stuff so If there is anything else I might need to make this work please let me know.

Thanks
-Rafael

 

[toolmanmike]

Read through this thread. There's part numbers listed. 2-Barrel to 4-Barrel Conversion

 

[C2ndLTpigeon]

Read through this thread. There's part numbers listed. 2-Barrel to 4-Barrel Conversion

Awesome thread, found the part numbers.

It says it will work with auto transmissions, so I assume it will work with the factory linkage? All I have just have to slide it on the new bracket?

 

[toolmanmike]

Awesome thread, found the part numbers.

It says it will work with auto transmissions, so I assume it will work with the factory linkage? All I have just have to slide it on the new bracket?

The 340 bracket is what you need. You might need to reverse your kickdown rod at the back of the intake. That should move it to the outside. The kickdown extension gives you the extra length you need for proper adjustment.

 

[C2ndLTpigeon]

The 340 bracket is what you need. You might need to reverse your kickdown rod at the back of the intake. That should move it to the outside. The kickdown extension gives you the extra length you need for proper adjustment.

Sounds good, thanks for the help!