[SOLD] 360, W2, 727

[jdwhitson1]

Mopar 360 (508hp) & 727 rev/manual trans.
.030 over, built by Jensen's. 4 bolt billet main caps, Scat forged crank, Eagle Rods, JE pistons. 12.2:1, W2 Econo heads, light porting, Edlebrock Victor W2 intake, port matched. Proform 750 carb. Crower solid lifter cam, Crane W2 Gold roller rockers (1.6 intake, 1.5 exhaust) with Smith Bros adjusters. QTF fab valve covers. MSD Pro Billet dist (8534). MSD 8.8mm plug wires. Moroso 63565 electric water pump.
TTI Headers - 340BEW2-C1 nickel step headers w/ Evacs.
727 reverse manual trans, B&M flexplate, 9-1/2" Dynamic converter. B&M deep pan. Trans blanket.
Best - 11.61 in my Belvedere.
Have lots of paperwork and dyno sheets.
Located in S.E. Pennsylvania (Harleysville)
Still in the car, can hear it run
$7500

 

[jdwhitson1]

I apologize for the bad form....registering and posting for sale. I search LA threads here a lot and thought I'd registered a while ago.

 

[go-fish]

Do you have accounts at any of the other Mopar forums? Username?
Is this posted anywhere else?

 

[jdwhitson1]

B Bodies.....it's DaveW......probably should have used the same name. Didn't think of that until just now.
Its posted on a bunch of FB Mopar pages through Marketplace.

 

[clementine]

That fella down under was looking for a 360. mick .....

Looking for an engine for a morris minor.

 

[go-fish]

@Mr Mick

 

[carguy47]

How long ago were the motor and trans built?
Approximate mileage on both?
What doesn't come with the package?

 

[jdwhitson1]

How long ago were the motor and trans built?
Approximate mileage on both?
What doesn't come with the package?

I bought it last year in the car.
The engine was built then wrapped and stored. It was installed in 2018.
Prior owner had a bunch of cars. Said it had 10 passes and only a few street miles. He was really good about documentation and receipts. I feel he was being honest with me about that also.
I have 20 passes on it and less that 200 street miles......probably less than 150.
Starter and alternator not included....other than that, it's complete from carb to tail shaft.

 

[Mtrhead]

Wanna trade for a 1968 d100 custom

 

[Mtrhead]

/6 with 3spd on column with 8.75 rear and 3.91 gears