[FOR SALE] 396 sb mopar for sale

[Brian Hafliger]

It's a 340 block that's been hardblok'd, 4.080 bore, 3.79 Molnar 4340 crank, Diamond small dome pistons, 6.200 Molnar H beam rods.
Custom Comp solid roller cam and lifters, Moroso pan, billet timing set and innovators west dampner.

Heads are Edelbrock rpm LA heads, fully ported, 2.055 x 1.60 valves, roller springs, JESEL 1.7/1.6 shaft rockers, .120 wall pushrods, 13.5:1 compression, Victor intake, dyno tested and tuned with a 1000HP carb, MSD distributor and wires...

660HP@ 7200rpm 515TQ@ 5600rpm $$$ 12,500 crated and shipped anywhere in the cont. U.S.

Brian- IMM Engines

I take credit cards, paypal, or certified bank checks...

 

[bignick]

What has been done to the block? Caps, filled, girdle?

 

[Brian Hafliger]

What has been done to the block? Caps, filled, girdle?

We hard blok'd the block, line honed it with arp studs. The stock caps are good for 700HP.
We bore our blocks with TQ plates after the hard blok, it's been zero decked with a smooth RA of about 15.
The short block is the same as in our CC article: http://www.hotrod.com/how-to/engine...-with-cast-iron-heads-on-a-mopar-340-stroker/

The heads are fully ported eddies with Jesel 1.7/1.6 rockers.