67 Barracuda front frame rail

[lvd2340]

I am in need of a left front frame rail for my 67 Barracuda drag car. The upper control arm mounts are rotted and the rail itself is cracked.

 

[Jim Lusk]

I have a good upper control arm mount, but the frame rail is cut near the end of where the inner fenderwell used to be. If you can fix the rail I can cut the mount off and sell it for $20 plus shipping or send all of what's left for $20 plus shipping.

 

[carguy392]

My 67 Cuda has a bad left ( drivers side ) frame rail . I will replace it , already have n o s
piece but they are available from Classic industries and check out (A B S)
Auto Body Specialties . Don't play games with the frame rail if it has several areas that are rusted away . I have patched some in the past , I cut back to good metal and butt welded new metal in . If you are bumping up the horse power considerably I recommend cutting the floor pan over the frame rails on right and left side then box them in as well as frame connectors . Good luck with your project

 

[Jimacuda]

I have a solid one from a 76 Duster, same other than the bumper bracket bolt holes. $150 + shipping from 85042.

 

[woody30]

PM sent.

 

[lvd2340]

This post is over 5-1/2yrs old, i found a perfect frame from Oregon not long after i posted this in 2008