[Found!] 67 Barracuda lower trunk trim fastener

[ZMan67S]

I'm looking for the lower trunk trim fastener found on a 67 Barracuda. They were a generic piece one on each end of the lower trim. Ya I know make one, but I want the challenge of looking for the right piece!! Thanks!!

 

[kursplat]

call DMT, those look just like the ones that came on my splash shields

 

[ZMan67S]

call DMT, those look just like the ones that came on my splash shields
View attachment 1715550461

Thanks, yep looked at those not quite what I need.

 

[RedFish]

That isn't OEM. The very end fastener that could catch clothing/skin/a ring had a closed nut. I can't find my picture of the aftermarket replacement 10-24 T stud but I can tell you its 3/4 inch is too long for the end closed nut application. Barracudakid may have what you need.

 

[ZMan67S]

That isn't OEM. The very end fastener that could catch clothing/skin/a ring had a closed nut. I can't find my picture of the aftermarket replacement 10-24 T stud but I can tell you its 3/4 inch is too long for the end closed nut application. Barracudakid may have what you need.

Thanks, I'll check with him. I'd seen them on more than one 67, so thought that's how they came.
That's why I've reached out to the FABO MOPAR brain trust!!
I'll check with him @barracudakid

 

[Cuda Al]

Half the problem in locating clips is knowing what the correct clip should be.
The correct clip for the rear trim on the 67 Barracuda is 88134
http://restorationspecialties-com.3dcartstores.com/assets/pdfs/page_123.pdf

They have many clips beyond this catalog, I recently contacted them with my need and they had the correct clip.


Alan