67 barracuda seat belt mounting location?

[WitchDr.]

Where do the lap BELTS for a 67 barracuda bucket seat mount? My car has carpet, no holes other than the 4 seat posts. I was assuming the big post in the lower seat is the mount location (that post the seat back rests against, but my new aftermarket BELT holes do not fit that). Photo anyone? Thanks!!

I’m fully rebuilding the seats this week, will take some videos if anyone is interested.

 

[bobruthkry]

Not sure but I seem to remember seat belts were required until 1968. Before that I believe they were optional.

 

[bobruthkry]

Supposed to say not required , sorry

 

[jawbone]

This is from 68 Barracuda with buckets. Remove sill plate and look on inside rocker panel.

 

[jawbone]

Forgot to include other side.

 

[4spdragtop]

67 cuda with buckets is same as 68 pics posted.

This is from 68 Barracuda with buckets. Remove sill plate and look on inside rocker panel.

View attachment 1716140017

Forgot to include other side.

View attachment 1716140025

 

[WitchDr.]

This is from 68 Barracuda with buckets. Remove sill plate and look on inside rocker panel.

View attachment 1716140017

Excellent, thanks!

 

[WitchDr.]

67 cuda with buckets is same as 68 pics posted.

Great, I’ll look harder under the car and likely remove carpet. I’m hoping my 67 has provisions. And I’ll get some hardened bolts

 

[jawbone]

Good luck.

 

[Cuda Al]

Supposed to say not required , sorry

Although they may not have been required they were standard on the 67 Chrysler/Plymouth/Dodge lineup.

Where the blop of sealant is on the tunnel and inside rocker.

Alan

 

[WitchDr.]

Carpet coming out tonight, and I’ll trim holes where these threads/nuts are, thanks!

 

[Cuda Al]

I have an old soldering iron that I use for stuff like this, run it through from the bottom with the carpet in place.


Alan

 

[jawbone]

Carpet coming out tonight, and I’ll trim holes where these threads/nuts are, thanks!

Good luck.