68 Dart GT convertible and other A-body parts wanted

[69GT]

Parts wanted for my 68 Dart GT convertible:

Black convertible rear side panels (mine are cracked)
Rear convertible ash trays (mine are rusty)
A set of straight GT body moldings (almost all of mine are all dented)
A black convertible top boot cover (mine has a big tear in it)
Lower windshield chrome rubber molding (mine is missing a big chunk)
A nice driver side taillight bezel (mine is pitted)
GT emblems for the trunk lid (mine are pitted)
A license plate light lens (mine has a large crack)
22” radiator fan shroud and bolts (car doesn’t have one)
Complete bumper jack set-up including the spring that holds it in place (all missing)
A nice windshield washer jar with electric pump (missing)
A radio/heater bezel that has already been cut for an aftermarket radio
A pair of stainless 2 ½” exhaust tips and hangers

Oother A-body parts that I am looking for:

Complete factory automatic kickdown linkage set-up for a 67-69 big block A-body.
68-69 A-body dash wiring harness for optional accessory light package (ignition, ash tray, glove box and courtesy light with switch). I don't need the entire dash electrical harness, just the optional light package harness.
A 68-69 Barracuda bench seat with center armrest and headrests (prefer located in southeast Michigan so no shipping will be required)
A pair of Moser, Strange, etc. stock A-body length big bolt pattern axles for an 8 ¾ rearend with standard 10”x1 ¾” drums
A pair of heavy duty A-body leaf springs like those found on a 340 car (again southeast MI area for pick-up)
A 73-up A-body small block k-frame with sway bar and lower control arms
A complete 73-up disk brake set-up
A nice pair of polished 15"x7" rally wheel trim rings
A nice pair of polished 14" rally wheel trim rings

If you can help with any of these parts, please PM me. Thanks in advance.

 

[69GT]

Anyone? :dontknow:

 

[newmexguy]

may have a few bits of windsheild moulding chrome, but thats about it.
since yours is convertible, it may very well be different.

68/69 Dart - two door hdtp
still have:
passenger door shell
flat hood
tinted side glass - both doors and quarters - wings and chrome frames are sold and shipped.
Back window - tinted, believe chrome trim is still around it
door latches, strikers, and regulators - manual roll up

 

[WildCat]

I have a set of convertible rear ashtrays. they have some spots on them but think they will clean up ok for a driver. no holes inside just some minor surface rust

are you looking to make an original looking car? my rear panels were cracked also. New black or white are available, but my blue would have to have been painted and didn't want the scratches that would come from painting them, so the interior guy covered them in the same material as the rest of the interior (reason I have the ashtrays, left them out and custom made longer arm rest)

View attachment rear side panel.jpg

 

[69GT]

"are you looking to make an original looking car? my rear panels were cracked also. New black or white are available"

Yes, I am hoping to keep it original looking. The new panels are far too expensive for my budget. Hopefully, I can find a decent set of used panels.