68 manual dash harness in a 67 automatic?

-
Cuda_Carl

Cuda_Carl

Active Member
Joined
Dec 27, 2008
Messages
32
Reaction score
10
Location
Venice, Florida
I'm rebuilding my 67 cuda vert automatic. I have a pretty good dash harness from a 68 cuda 4 speed car. Any glaring issues with using the 68 harness that anyone can think of? It has very little time on it.
 
I don't think there were many changes, you'd want to consult a diagram.. The 4 speed harness will have the back up lamps fed out through the bulkhead, to the 4 speed. If you are using a later auto with the 3 pin neutral safety, that would work out fine. Otherwise, your reverse lamp switch is on the shifter linkage, IE column or in the console.

You have a shop manual?
Download them here. Nothing in these, though about the special stuff for the 'Cuda Rally dash. I believe there's a 67 and 69, no 68, but the 68 -- 9 should be close to each other

http://www.forabodiesonly.com/mopar/showthread.php?p=1970088657
 
You must log in or register to reply here.
-

Back
Top