THE DART Member Joined Apr 17, 2013 Messages 24 Reaction score 0 Location Ontario May 27, 2013 #1 My Dart has recently has an issue when trying to get it out of reverse, it takes a few minutes of moving the shifter around, depressing the clutch, and finally it will pop out, anyone had this issue before??:?
My Dart has recently has an issue when trying to get it out of reverse, it takes a few minutes of moving the shifter around, depressing the clutch, and finally it will pop out, anyone had this issue before??:?
Rocky_JS 'cuda Joined Feb 27, 2011 Messages 4,187 Reaction score 347 Location Highland Maryland May 27, 2013 #2 probably in need of a linkage adjustment
THE DART Member Joined Apr 17, 2013 Messages 24 Reaction score 0 Location Ontario May 27, 2013 #3 Where do you make that adjustment, i guess it gets loose over time? Thank you
Rocky_JS 'cuda Joined Feb 27, 2011 Messages 4,187 Reaction score 347 Location Highland Maryland May 27, 2013 #4 if it were close it could have worn/loose and becomes tough to shift [ame]http://www.hurst-shifters.com/wp-content/uploads/3737437.pdf[/ame]
if it were close it could have worn/loose and becomes tough to shift [ame]http://www.hurst-shifters.com/wp-content/uploads/3737437.pdf[/ame]
THE DART Member Joined Apr 17, 2013 Messages 24 Reaction score 0 Location Ontario May 27, 2013 #5 thanks very much for the attachment , will have a look.
TrailBeast AKA Mopars4us on Youtube Joined Mar 11, 2011 Messages 22,475 Reaction score 12,004 Location Arizona May 27, 2013 #6 Is it hard to get into or out of any other gears? If not it's probably just the linkage adjustment needed.
Is it hard to get into or out of any other gears? If not it's probably just the linkage adjustment needed.
THE DART Member Joined Apr 17, 2013 Messages 24 Reaction score 0 Location Ontario May 27, 2013 #7 No only gets stuck in reverse, i hope it is the linkage Thanks
cudavert DARTAHOLIC Joined Apr 16, 2009 Messages 2,867 Reaction score 517 Location Hesperia, CA May 27, 2013 #8 Yup, shifter linkage, I'll bet......mine used to do the same thing.
swinger340 Well-Known Member Joined Jul 25, 2010 Messages 2,273 Reaction score 61 Location Maine May 27, 2013 #9 Mine did the same before tightening everything up and adjusting linkage
THE DART Member Joined Apr 17, 2013 Messages 24 Reaction score 0 Location Ontario May 28, 2013 #10 OK will try adjusting, thanks very much everyone.