72 Demon Ride Height Question.

-
Mr.FT

Mr.FT

Well-Known Member
Joined
Feb 14, 2011
Messages
864
Reaction score
45
Location
New Jersey
Can anyone tell me the stock height of the rear bumper to the ground? Trying to decide on Stock height rear springs or +1"

Thanks
Tom
 
There is no "one" measurement. The road height is the difference between two measurements. Measurement "A" is the one from the bottom of the front torsion bar anchor to the ground and measurement "B" is the from the bottom of the lower ball joint to ground. The difference on your car should be 1 5/8" (at least the Duster is and I'm assuming the Demon is the same) These measurements have to be taken with the car on level ground, with a full tank, tire pressure correct, no people inside, and all the extra junk out of the trunk. Make sure both sides are within 1/8" of each other.
 
The rear height will be determined by how good the springs are. Set the front first and see if you like the rake of the car.
 
Go with the 1" over ESPO springs. Springs always settle and you can adjust your rake some with your torsion bars.
 
My SS springs settled a full inch maybe a bit more in three years.
 
You must log in or register to reply here.
-

Back
Top