727 clutch pack clearance

[CudaFactHackJob]

I don't think you can use that same trick because the ridge will interfere. Only use that ridged plate on a three plate direct drum. You already evened things out.

 

[Mojack]

What I was thinking was, now there's 4 sets in the front clutch pack but still 3 sets in the rear clutch. Is that ok, or does it make adding the extra set to the front pointless?

 

[CudaFactHackJob]

Are you saying that you only have three .062 clutches in the rear drum? Or did somebody stick .092s in there?

 

[CudaFactHackJob]

Sounds like you're working on a slant six 904.

 

[67Dart273]

From the snap ring groove down, you can see the difference. Once you see them side by side.

OK but I mean let's say you are somewhere and you come across an empty drum. Is there a spec somewhere you can measure and figure what they are? Identify them?

 

[CudaFactHackJob]

OK but I mean let's say you are somewhere and you come across an empty drum. Is there a spec somewhere you can measure and figure what they are? Identify them?

See posts 20 and 22.

 

[Mojack]

Are you saying that you only have three .062 clutches in the rear drum? Or did somebody stick .092s in there?

Sorry, my mistake, I looked again and it had 4 disc .062 .

Many many thanks for all the advice, especially the stuff that the books don't tell you!