727 passing gear kickdown throttle bracket

[bbmopars]

Do you know if this would work with headers to,with the 70-76 abody big block swaps to?i put a 68 440 into a 71 dart im runnin Schumacher headers.i tried c-body and b-body levers they hit the some of header flange and bolt.67-69 Mopar A Body 383 440 Barracuda Dart Transmission Throttle Kickdown Lever | eBay

 

[bbmopars]

Do you know if this would work with headers to,with the 70-76 abody big block swaps to?i put a 68 440 into a 71 dart im runnin Schumacher headers.i tried c-body and b-body levers they hit the some of header flange and bolt.67-69 Mopar A Body 383 440 Barracuda Dart Transmission Throttle Kickdown Lever | eBay

possibly this one instead?Mancini Racing - Transmission Bell Crank Pivot Assembly

 

[Jim Lusk]

I've never seen the top part. I have similar on my '67, but I'm also not running headers so I have plenty of clearance.

 

[oldkimmer]

It all depends on how wide the bracket is. They have made a few different widths over the years. Is urs just sticking out too far from the tranny? Some may also be clicked a bit different too, idk for sure. Kim

 

[oldkimmer]

I have doubles of some. These sets are different widths. I also have some on complete linkage set ups.

 

[bbmopars]

It all depends on how wide the bracket is. They have made a few different widths over the years. Is urs just sticking out too far from the tranny? Some may also be clicked a bit different too, idk for sure. Kim

Its hittin the header bolt and flange alittle causin the kickdown lever on transmission not to go back.i have two 1968 b-body brackets.

 

[bbmopars]

It does stick out alittle and hit header bolt.i might modify the bracket i have so it would clear it.