alleyoopmgv
Well-Known Member
74 Satellite Roadrunner clone
Located in Wisconsin zip: 54022
Trade value: around $8000.00
The hood in the picture is just not closed all the way, it fits fine. Have bulge hood also, keep reading.
This car could be a totally different car come next summer, if I get off my a$$ and work on it.
Preferably A-body Mopar trades, but I'm open to any Mopar trades.
It is a pretty solid car, solid floor pans, solid trunk pan, and good quarter extensions. Needs a little outside drivers side quarter work. down low in front of rear wheel. The paint job is about a 5 out of 10. driver quality.
Here is the rundown: estimated 525 horsepower
74 Road Runner Clone
- 440 and transmission from a 71 Imperial
-10.5-1 Keith Black pistons
-Race ported 1976 heads with Indy valves
-Crane gold race rockers and springs
-Mopar Performance .590 solid purple shaft cam
-Mopar Performance electronic distributor
-MSD 6a
-Dynomax ceramic coated headers
-3 inch exhaust with Flowmaster 40 series mufflers
-Edelbrock Torker 2 intake
-Demon 850cfm carb
-Professionally race built 727 with Cheetah reverse manuel valve body
-B&M pro stick
-Boss Hog 3800 stall converter
-9.25 rear with 4.10 gears
-Weld Draglite wheels
-Has run a 12.03 best in the 1/4 mile
I also have a power bulge hood, that needs to be repainted
I also have another set of rear seats and front buckets for the car, one will need to be recovered. Also have another set of door panels from a Satellite front and rear, and misc. interior trim.
Located in Wisconsin zip: 54022
Trade value: around $8000.00
The hood in the picture is just not closed all the way, it fits fine. Have bulge hood also, keep reading.
This car could be a totally different car come next summer, if I get off my a$$ and work on it.
Preferably A-body Mopar trades, but I'm open to any Mopar trades.
It is a pretty solid car, solid floor pans, solid trunk pan, and good quarter extensions. Needs a little outside drivers side quarter work. down low in front of rear wheel. The paint job is about a 5 out of 10. driver quality.
Here is the rundown: estimated 525 horsepower
74 Road Runner Clone
- 440 and transmission from a 71 Imperial
-10.5-1 Keith Black pistons
-Race ported 1976 heads with Indy valves
-Crane gold race rockers and springs
-Mopar Performance .590 solid purple shaft cam
-Mopar Performance electronic distributor
-MSD 6a
-Dynomax ceramic coated headers
-3 inch exhaust with Flowmaster 40 series mufflers
-Edelbrock Torker 2 intake
-Demon 850cfm carb
-Professionally race built 727 with Cheetah reverse manuel valve body
-B&M pro stick
-Boss Hog 3800 stall converter
-9.25 rear with 4.10 gears
-Weld Draglite wheels
-Has run a 12.03 best in the 1/4 mile
I also have a power bulge hood, that needs to be repainted
I also have another set of rear seats and front buckets for the car, one will need to be recovered. Also have another set of door panels from a Satellite front and rear, and misc. interior trim.
