funkyflynz
Well-Known Member
Im installing an RMS AlterKation and i noticed that my camber is different on each side, even though i have the heim joints all set the same on the upper control arms.
Turns out the front frame rails arent parallel to each other, one is on a slight lean, this of course affects the amount of camber i can get from that side.
Now i could simply adjust the heim joints so both sides have the same camber, but i would have thought it was important to have both frame rails vertically parallel to each other so both upper arms are the same length.
I guess its also possible that the factory upper arm mounts werent welded in the correct location on one side and this could also be throwing out the upper control arm.
Any thoughts on what to do would be appreciated.
Turns out the front frame rails arent parallel to each other, one is on a slight lean, this of course affects the amount of camber i can get from that side.
Now i could simply adjust the heim joints so both sides have the same camber, but i would have thought it was important to have both frame rails vertically parallel to each other so both upper arms are the same length.
I guess its also possible that the factory upper arm mounts werent welded in the correct location on one side and this could also be throwing out the upper control arm.
Any thoughts on what to do would be appreciated.