Alberta Guys!

[71Duster]

Ok heres the deal I need a driveshaft for my 71' with a 727 and 8 3/4 741 case.

My car has a poorly shortend unbalanced one from a 76 Gran fury four door. This I know because it has the junk yard grease pencil markings on it. I can hear slag inside it rolling around even.

If anyone has one int he province and wants to sell it let me know

 

[Dorian]

hi,

will a drive shaft from a 68 318 Barracuda fit?

I believe it has a 904 with a 7 1/4 rearend.

Gary

Medicine Hat

[email protected]

 

[71Duster]

Not sure, anyone here know?

 

[65Val]

Nope, dont think it's gonna fit. The 904 slip yoke will fit in the 727 trans,but,I believe the 727 has longer tailshaft. If not, the 8 3/4 is definitely longer in the pinion area than the 7.25. You'll have to get that shaft shortened regardless.


Hope this helps...

 

[Jims71duster]

there is a factory one that fits,,,problem is I don't know which one. I bought my duster and it had a drive shaft and a 4 speed in the trunk. sold the 4 speed but put a 383 and a 727 (it already had the 83/4 in it) in the car. Tryed the drive shaft just for ***** a giggles and it fit. So I don't know if the shaft was from the donar 300 or came with the 4 speed but it wasnt custom made