fishy68
Tyr Fryr's Inc.
Nice used 24" total width aftermarket aluminum radiator. Not sure who made it as it came from FBO in an unmarked box. Looks just like most of the other universals I've seen though. Has mounts welded to it and it bolted into my 68 Cuda with some of the factory bolt holes on the core support, but only a couple (drivers side I believe) original radiator mounting bolt holes were used. On the pass side my core support had 2 other holes that I used to bolt it too. Has about 6000-7000 miles on it and cooled my old 360 (approx. 350 hp) just fine. It's a 2 row with 1" tubes. Along with it I have the shroud I used with a 17" clutch fan but I re-used the fan with my new radiator when I installed the 408 so no fan is provided. I also have a real good water pump to intake bypass hose and good top radiator hose I'll throw in on the deal. All have 6000-7000 miles on them. Oh yeah there's a top cover plate for the radiator also. Has some scratches in it. You may not even want to use it but it's there if you do want it.
BTW: you'll notice in the pics the shroud is cut out offset and right at the pass edge. That's because I centered the radiator in the core opening, instead of in front of the engine. It worked fine with a 17" fan in my car but due to some core supports being slightly different I will not absolutely guarantee it's a perfectly direct bolt in. I believe that it'll work in any 67-up (maybe even 64-66?) A-body but be aware you may have to drill some extra holes but that should be the worst of it.
$200 obo plus shipping (or free pickup 50 miles ne of St. Louis) for the whole shebang. Postal money orders or PayPal accepted. I have a nice double wall box that all these will fit in so the shipping will be just 1 charge. I only have the post office and UPS near me so I will check shipping prices with both and get you the best deal I can or if you prefer one shipper over the other just tell me.
PM me if interested.
See my other ads for other cooling related parts.
BTW: you'll notice in the pics the shroud is cut out offset and right at the pass edge. That's because I centered the radiator in the core opening, instead of in front of the engine. It worked fine with a 17" fan in my car but due to some core supports being slightly different I will not absolutely guarantee it's a perfectly direct bolt in. I believe that it'll work in any 67-up (maybe even 64-66?) A-body but be aware you may have to drill some extra holes but that should be the worst of it.
$200 obo plus shipping (or free pickup 50 miles ne of St. Louis) for the whole shebang. Postal money orders or PayPal accepted. I have a nice double wall box that all these will fit in so the shipping will be just 1 charge. I only have the post office and UPS near me so I will check shipping prices with both and get you the best deal I can or if you prefer one shipper over the other just tell me.
PM me if interested.
See my other ads for other cooling related parts.
