Here is another project I have been working on today 10/11/2025.
Making a "Home-Brewed" Cam Position Sensor/Distributor hold down clamp.
This started out as a piece of 1/4" x 1 1/2" x 2 1/2" Aluminum angle.
I had an idea of what I wanted. No plans. Just started drawing lines and cutting.
This is what I ended up with.
Making a "Home-Brewed" Cam Position Sensor/Distributor hold down clamp.
This started out as a piece of 1/4" x 1 1/2" x 2 1/2" Aluminum angle.
I had an idea of what I wanted. No plans. Just started drawing lines and cutting.
This is what I ended up with.
