[SOLD] Anyone need slant six tranny parts before scrap

[drive48]

I have several slant six automatic tranny's and mounts and bare cases, i will be stripping down and i will be sending to scrap saturday 10/06/2012. If you need any hard parts let me know before then. Thx joe

 

[srixon4406]

Do of have any low gear sets for post 67 904 non lockup

 

[drive48]

Do of have any low gear sets for post 67 904 non lockup

will dig through them and let ya know



"oldkimmer" i pm'd ya on the 3.8 front levers... joe

 

[drive48]

Do of have any low gear sets for post 67 904 non lockup

ok my 904's should be non-lock-up because they have splines to the end of the input shaft and no thru hole.
they were removed from a 68 cuda and 4 72-4 dart swingers
i have good clean parts if ya still need.

 

[kittypancake]

Do you have any with 2.74 low gear?

 

[scamp 408]

What ratio is the kd lever and flip vb over tak a pic

 

[mischiefdart]

Any /6 727 cases?

 

[Wrencher]

I sure could use the lever that the kickdown linkage hooks to.

 

[fishy68]

Do you have a couple good speedo pinion housings? Don't need the gears, just the housings. You can PM me if you like.

 

[drive48]

Do you have any with 2.74 low gear?

pouring today but i will continue tearing down trannys this weekend and post on low gear sets.

What ratio is the kd lever and flip vb over tak a pic

i will get the pics and info by sunday for ya

Any /6 727 cases?

i believe 1 left and will get pics sunday

I sure could use the lever that the kickdown linkage hooks to.

i have several pm address to me u pay shipping

Do you have a couple good speedo pinion housings? Don't need the gears, just the housings. You can PM me if you like.

yes and i will get pics quantity and pm ya

 

[Wrencher]

Done, thanks

 

[T56MaxTorq]

Hello, looking for a later untouched 904 Valve Body (mid 70's)

I also need a better condition 904 regular ratio gear set. Can you take some pics up close? My gears have very worn teeth.

 

[lvd2340]

I may be interested in a case