Anyone use exhaust Cutouts?

[scott2683]

I've been thinking of buying some cutouts for my exhaust and having them welded on just past my headers. Are any of you guys running these? Any issues with them? I have 2.5" exhaust, so 2.5" cutouts would match and weld up ok?

I'm looking at these possibly.

http://www.jegs.com/i/Flowtech/387/53026/10002/-1

http://www.jegs.com/i/Race-Ready/815/Y250/10002/-1?parentProductId=827395

 

[71swing]

I have the very same Flow Tech ones on my Dart. I installed them in the front section of my H pipe. They bolt right to the header flanges. I have my cut outs on the inside rather than facing out from the car. I think it was a lack of ground clearance or part of the frame that prompted me to do it that way. For the most part they stay closed. But if I go to the track I have a set of turn downs I can bolt on in place of the blocking plate to direct the exhaust down and out from the car.

 

[plum crazy dart]

I have some. I made some caps that cover a little less than half of the opening, but I usually run them open. Everyone loves the way it sounds.

 

[ddettloff]

Have them on mine with electric control lots of fun pulling up to the Honda's flip the switch and scares the hell out of them

 

[MOPAR MADMAN]

I've been running QTP's cut outs for 3+ trouble free years

 

["Dart67"]

I have had a set of cutouts from here http://www.dmhperformance.com/ for 12 years now without any problems at all with them.

The only thing I have had to do was replace the momentary on off on rocker switch.

Herb

 

[PA Dodger]

http://www.forabodiesonly.com/mopar/showthread.php?t=218522&highlight=exhaust+cutouts

 

[chryslerman6772]

i have them on my big block dart & duster. sound is aweasome. even have a noisy gear drive to on my dart as well.

 

["Dart67"]

Here is a photo oh my setup.

View attachment UnderSide.jpg


Herb