[SOLD] Barracuda 1/4 panel
- Thread starter RAT ROD AL
- Start date
-
- Status
Hey Al, that fuel cap area is sought after!
Yes, I also have 2 fill tubes available..
67-69
Let me see what size box and get you a price
Here's what I have left of this panel.
If you need a piece let me know.
Panel in bottom pic has been sold
If you need a piece let me know.
Panel in bottom pic has been sold
Last edited:
modtopcuda
Active Member
I could use a filler tube for a 69 Barracuda. I could also use the front of the quarter panel but it looks creased in that area. Alberta Canada.
The Panel does not have any dings , dents or creases. as new condition. The curvy tube is from a 67 Fastback cuda, should be the same as a 69 I would think. Shipping a good sized box to Canada will be pretty pricey
modtopcuda
Active Member
I need filler tube for a notchback so that won’t work. How much do you want for the panel and shipping? Not sure how you would pack it. Wrap it in bubble wrap and send it? I could really use that piece.
Only piece I have left, left side rear portion..$45 + the ride.
Last edited:
mrtruvalue
Member
Here is the last piece of panel I have left. Look close at the measurements I have on it. The bottom edge has been cut off 9".
It is the top portion of the left side, rear with the taillight section intact.
No dents or dings. Was a new panel.
It is the top portion of the left side, rear with the taillight section intact.
No dents or dings. Was a new panel.
- Status
-
