Bench seat mounting measurements???

[Devildodge]

Can anyone here help me get the side to side,front to back measurements for the bolt pattern on a 1971 dart swinger bench seat bracket??? TIA Also,distance between front/rear hole locations,also center to center of front/rear holes.

 

[hemi71x]

new member, Devildodge.
Your posting in the wrong forum.
A moderator will most likely move you over.

 

[Dana67Dart]

Note I started at 2"

So overall center to center is 12 3/16 to 12 1/4

 

[Devildodge]

Note I started at 2"

So overall center to center is 12 3/16 to 12 1/4

View attachment 1716400506
View attachment 1716400508View attachment 1716400509

How about the driver side front hole,to the passenger side front hole?

 

[Devildodge]

How about left front hole,to right front hole? Thanks for the front to back #.

 

[Dana67Dart]

I can get the dimensions but they will go over the hump and the car is not high enough to get under it.

 

[Devildodge]

I appreciate the effort. A "close enough" measurement should do. Thanks again.

 

[Dana67Dart]

The tape is only slightly bent over the hump

The screwdriver was only there to keep the tape touching the drivers side

Started at 1 inch

So overall is 47"

 

[Devildodge]

Thanks a lot for the info.