65Vart
Well-Known Member
Guys, I want to swap my stock coil for a MSD Blaster 2 coil. Car currently runs a Mopar orange controller . What ballast resister should I purchase.
Blaster 2 coil with Orange box
- Thread starter 65Vart
- Start date
-
You can buy a blaster 2 that comes with the ballist resister.
65Vart
Well-Known Member
yes , a .8, but is that ok with the orange box?
G.Ballast Resistors - Electronic Distributor 1P5206436 1P2444641 Ballast Resistor, For Electronic Ignition Systems, Using P4120505 Orange Box and Production Coil, or With P4120889 Coil, 1 OHM
Page 10 [ame]http://www.mopar.com/assets/pdf/performance/catalog/Ignition_&_Electronics.pdf[/ame]
Mopar recommends 1 ohm. With their coils, maybe anything lower will cause too big of a current draw for the ecu.
Page 10 [ame]http://www.mopar.com/assets/pdf/performance/catalog/Ignition_&_Electronics.pdf[/ame]
Mopar recommends 1 ohm. With their coils, maybe anything lower will cause too big of a current draw for the ecu.
65Vart
Well-Known Member
works the other way too, that's where the confusion is. Too much and you can fry the coil. Anybody running the MSD supplied resistor .8 with the Orange ECU?
dusterdragracer
Drag Racer
Blaster 2 didn't work for me....others say it worked.
http://www.forabodiesonly.com/mopar/showthread.php?t=190192
http://www.forabodiesonly.com/mopar/showthread.php?t=190192
-
