Bolt on exhaust kit

[Speed Junkie]

I need to get an exhaust for my 1968 Plymouth valiant equipped with a 225 slant six with a 3 on the tree. I was wondering what brands you guys run or prefer for a bolt on exhaust kit.

 

[Car Nut]

TTi

 

[Dana67Dart]

Accurite exhaust, don't know if they have slant 6

 

[WV64Signet]

Accurite exhaust, don't know if they have slant 6

I need to get an exhaust for my 1968 Plymouth valiant equipped with a 225 slant six with a 3 on the tree. I was wondering what brands you guys run or prefer for a bolt on exhaust kit.

See Below-63-74 A Body 225 Slant/6 Complete Exhaust System

 

[Speed Junkie]

Thankyou for the replies. I think I’m going to go with accurate exhaust. If they don’t have slant six I might just go with TTI

 

[roccodart440]

I need to get an exhaust for my 1968 Plymouth valiant equipped with a 225 slant six with a 3 on the tree. I was wondering what brands you guys run or prefer for a bolt on exhaust kit.

I made my own out of 3" stainless and some pre-bent elbows. 6/1 header with a 3" collector. Borla SS mufflers. Obviously you can use mild steel if you want to cut cost a bit, but it rusts, hence why people replace exhaust systems.

 

[Speed Junkie]

Thankyou, I went through Acurite exhaust and it’s good so far. The only problem is that it hangs a little too low and hits the Z bar up front

 

[roccodart440]

Pipe and a BFH will fix that

 

[Mike69cuda]

Waldron Exhaust. Reasonably priced & good quality.