At the risk of opening a can of worms I have a question for you engine gurus. I'm installing cam bearings. I have 1 with the oil hole just a little off center. Can I push it through and try again or is the bearing toast and get a new one?
Cam bearing question
- Thread starter 737jetdr
- Start date
-
Push it out and reinstall it.
Thanks. That's what I was hoping to hear. Hate to waste a set of bearings but I did buy 2 sets just in case.
Plymouth 65
I'll be in the shop
I've seen them installed that way from the factory truthfully. 65'
How far off center is it??? If it's not that much, just run it as is....
Just a tad. I'm pretty much over it. Going to do just that. Thanks.
-
Similar threads
