Cam bearing question

-

737jetdr

FABO Gold Member
FABO Gold Member
Joined
Jun 15, 2007
Messages
848
Reaction score
258
Location
Martinsville, In.
At the risk of opening a can of worms I have a question for you engine gurus. I'm installing cam bearings. I have 1 with the oil hole just a little off center. Can I push it through and try again or is the bearing toast and get a new one?
 
Turn it around or rotate it to the next hole.
 
Thanks. That's what I was hoping to hear. Hate to waste a set of bearings but I did buy 2 sets just in case.
 
How far off center is it??? If it's not that much, just run it as is....
 
-
Back
Top