Cast Iron Aluminum?????

[ocdart]

Leave it to good ol' "Ford Joe" on the "Horsepower" tv show.
I was watching it today even though they were doing a small block Ford build and "Ford Joe" comes on telling everybody that because of the budget build they're doing, they're using "cast iron aluminum" cylinder heads.
CAST IRON ALUMINUM?????
Must be a trick new material suitable only for Fords.
I couldn't believe my ears and rolled it back to listen to it again, then asked my wife to listen just to verify what he said.
I've seen out takes from this show before so I know they've caught some previous errors, but this one was loud and clear.

 

[Twisted72]

I don't watch them very much anymore since Chuck Hanson hasn't been there.

 

[grumpuscreature]

That's probably the best they could get out of him. Poor guy trips over his tongue saying "Hello". Just remember, he did have to say "aluminum".

 

[chuckwagon2004]

Will be sure to listen to it when i get home in a few weeks. I love my DVR even if its to watch horsepower LMAO. I like Muscle Car and of course Courtney

 

[1wild&crazyguy]

they don't even know that too much octane burns slower and can make no more if not less than a lower octane...they suck!

tim the toolman taylor knew that...it's on the show 'home improvement'.

 

[72DusterOwner]

I cant stand to watch that show. TRUCKS has gotten stupid in the past couple years also. All I watch these days is MUSCLE CAR and XTREME 4X4.

 

[CudaChick1968]

Oh man, I hope nobody sends me any of that to coat. LMAO