[SOLD] Clean out in the "E body " Aisle

-
Status
Not open for further replies.
RAT ROD AL

RAT ROD AL

MOPAR ARCHAEOLOGIST - one parts hoard at a time!
FABO Gold Member
Joined
Jan 18, 2013
Messages
7,844
Reaction score
10,487
Location
Robbinsville, North Carolina
Rating - 100%
262   0   0
Contact seller
I know a lot of you guys have some E bodies.. Hope I don't make everyone mad !
Price Plus shipping from FL, 33956. PayPal.
Please Claim Parts Here by # listed !

#1
I have 2 motor/pumps for a vert top Both work good ! $150 each
One cylinder , tested with air and appeared to work properly ! $80
20211029_124426.jpg


#2

...SOLD...V8fish...
STILL ONE SET AVAILABLE
2 sets of Rear bumper brackets 70 Challenger . $50 Good condition
20211129_153136.jpg



#3

Trunk pan support and tank strap . $20 each
20211129_153711.jpg




#4
....SOLD...MoparMark...
Passenger door parts $10 for the lot
20211129_162643.jpg



#5
Console plates . Good shape , but needs new wood grain decal ! $20 each. Bottom one has the best chrome.
20211129_163022.jpg



#6
2 pedals and cable sold..
plastic dash parts sold.... V8fish.
Your choice $10 each
20211129_163410.jpg




#7.....sold ...RustyCowl....
$25 for the cluster
20211129_163430.jpg




#8
Challenger rear window trim , 2 sets $75 each. Also a couple other single pieces $10 each.
20211029_105710.jpg



#9
Challenger inside rear window trim $10
20211029_105940.jpg



#10
Challenger 72 I think. $30
20211123_122458(0).jpg



Claim parts by # listed . Scroll on down for more parts !
 
Last edited:
Claim parts here by # listed !

#11
Good driver condition $100. No cracks !
20211110_113520.jpg



#12
$75 for this one . No cracks either !
20211110_113642.jpg


#13
$150 for this one. No cracks , has some scuff marks on the wood grain grip. The horn par is nice.
20211110_113727.jpg



#14
....SOLD...Superbee6...
$75 for a driver quality set of mirrors. Cuda , maybe challenger also ?
20211123_122156.jpg



#15
Cowl vent mesh. $45. Top piece is missing the snap in prongs on the lower left side.
20211127_102318.jpg



#16
Pair of splash shields. As you can see in the pic . One is good and one not so good ! $40 for the pair
20211127_105414.jpg



#17
Front of fender seal $25. Good shape
20211127_105904.jpg



#18
"Not E body"
Defrost hoses . $15 for the pair ! Good shape. Only split is on the top one on the very end.
20211127_110301.jpg



#19
....sold... Michael..X
Rear window defrost. Motor works good. $75 The end of the base plate was folded over. Little body work , good as new ! Almost !
20211127_114857.jpg




Thanks for looking and please claim parts by # listed !
Keep scrolling down for more parts.

20211127_105424.jpg
 
Last edited:
#20
......sold... goldduster..
Shoulder Belt keepers . $5 for the pair
20211123_121901.jpg




#21
Door seal ends in good shape . $15
20211123_121923.jpg



#22
Exhaust pipe hanger $8
20211123_121937.jpg




#23....SOLD.....
Full set of disc, Has new inner wheel bearings. 10.75" Rotors and pads look great. Will need grease seals and spindle nuts and washers.
$500 for all in the pic, B & E body.
20211129_152837.jpg


#24....sold...
OEM disc. $350, all in clean, good condition.
20211129_153226.jpg



#25
...SOLD...MoparMike....
$50 for a pair of UCAs E body
20211129_153119.jpg



#26....sold....
Remanned Calipers. Has the 2.75 pistons . New un-used. $125 for the pair.
20211129_153311.jpg



Thanks for looking ! and plaese claim here , by # listed !
 
Last edited:
Just a note or two.
The convertible top pumps also fit A and B bodies.
The console tops also fit 71-4 B body
The mirrors are 71-4 E and 71-2 B bodies.
The defroster tubes are not E body
The OME disc brakes also fit 62-72 B body and will fit A body with the 73-4 A body upper control arms.
 
Would you sell the spindles separately in #24? THe rotors would weigh too much for shipping. This would be to convert a car that has drums so we already have upper control arms.
Thanks for the consideration.
 
go-fish said:
Would you sell the spindles separately in #24? THe rotors would weigh too much for shipping. This would be to convert a car that has drums so we already have upper control arms.
Thanks for the consideration.
Click to expand...
Give it a couple days , If they don't sell , I will split em up !
 
Status
Not open for further replies.
-

Back
Top