Air Grabbler
Active Member
Hello,
I’m pulling the engine out of my SS Barracuda clone and noticed that the torque shaft bracket has been modified, but is still causing a misalignment of the shaft.
I have Schild’s authenticity guide that shows the mod, but I cannot make out the numbers that would allow me to perform the proper mods.
Can anyone provide the measurements or a better copy of the drawing?
Thanks!
I’m pulling the engine out of my SS Barracuda clone and noticed that the torque shaft bracket has been modified, but is still causing a misalignment of the shaft.
I have Schild’s authenticity guide that shows the mod, but I cannot make out the numbers that would allow me to perform the proper mods.
Can anyone provide the measurements or a better copy of the drawing?
Thanks!
Last edited:
