conical exhaust manifold washers

-
I bought mine from
http://www.restorationperformance.c...1968-dsh-70-Mopar-273-fdsh-318,-Engine/Detail

or direct from

https://www.amkproducts.com/

However I wanted all new fasteners.. You can get the washers by themselves from R/T specialties as well as all over ebag...

Hope this helps. I would reccomend all new hardware for the exhaust manifold since they get brittle over time because of the heat up and cool down over the years. Case in point rebuilt the 273 in my wifes cuda and put the ends studs back in and the first one I torqued it broke off and fell into the head. It was good that it was on the engine stand so I could tip it over and it fell out.


Randy
 
Call your local dodge chrysler dealer.

part # 53010091 listed as : clamp, exhaust manifold. list of $2.35
 
I'm not sure about all years of the SB but the ones I've seen don't use those washers on the center two fasteners...just the outer ones.(8 total per engine)
 
My 86 5th Ave parts car had them.

They still turn up in U-pull yards frequently.
 
You must log in or register to reply here.
-

Back
Top