okay im restoring a 68 dart and it was orig a bench seat car and someone put buckets in with a aftermarket shifter, however i got a console with a stock shifter, whats the best way going about mounting the center console to the floor sense i dont have the brackets
console questions
- Thread starter dartkid68
- Start date
-
bbrroowwnn
never re member
Buy the brackets
Just spot welded to the floor. The brackets aren't that complicated either, if you're decent with sheet metal and not concerned about it appearing 100% stock you could fab them yourself.
bbrroowwnn
never re member
Yes, usually you can find some for sale here....It would really be the easy way to go
Rocky_JS
'cuda
best to screw the brackets in first to make sure the console is positioned correctly and then tack weld. pretty easy
zigs
Well-Known Member
I found it easier to line up shifter linkage and shifter box, tack then work on front and back brackets . you can make your own brackets. Should be a couple holes in counsol ,in storege area where mounting screws go. Set the console over the shifter box and line it up , it will fit slightly to the drivers side. get a small long piece of metal rod put it through the screw holes and tap to mark position ,so on an so on.
-
Similar threads
