[WANTED] Crank pulley single groove

[65 Valiant]

Hi guys,

after a long period of beeing lazy, i started to work at my 65 Valiant again.
Looks like i can get it on the street the next spring.

What i now need is a crank pulley-single groove- which must be about 2 3/4 inches deep
Small block please.

if its not even 2 3/4, let me know what you have. Perhaps i can work with a spacer...

thx for looking

 

[hippy 60]

Hi guys,

after a long period of beeing lazy, i started to work at my 65 Valiant again.
Looks like i can get it on the street the next spring.

What i now need is a crank pulley-single groove- which must be about 2 3/4 inches deep
Small block please.

if its not even 2 3/4, let me know what you have. Perhaps i can work with a spacer...

thx for looking

I have a single groove pulley from a 273 if it will work

 

[dadodgekid]

I have a couple i can measure tonight.

 

[65 Valiant]

I have a couple i can measure tonight.

that would be fine. I can also buy a 3/16 spacer on ebay if the pulley is not deep enough. But easier for me to install without a spacer.

thx

 

[hippy 60]

that would be fine. I can also buy a 3/16 spacer on ebay if the pulley is not deep enough. But easier for me to install without a spacer.

thx

The one i have is 2 inches from the bottom to the top it came off a 66 273 only one i have.......

 

[65 Valiant]

The one i have is 2 inches from the bottom to the top it came off a 66 273 only one i have.......

thx for looking but this will not fit my setup...

 

[65 Valiant]

mo one?

pls take a look...

thx