Dart is ready to fire

[superbeesrt8]

I got all the wiring and plumbing done on my dart I’ve been working on for the last 2 yrs it’s a 417 inch W9 motor hoping to make some test pass real soon

 

[Biff]

What do you gota do to get 417 cubes ? And what sorta hp# thanx.

 

[yellow rose]

Whose carb is that and did you have a chance to get it on the dyno?

 

[rustycowll69]

that's quite a cage. How fast do you expect to go in the traps?

 

[superbeesrt8]

It’s a old truck block 4.185 bore 3.79 crank 14.5 compression it’s a APD carb 1450 cfm should make around 860

 

[superbeesrt8]

I’m going to put a 300 plate system on it should go low 9 s on the motor

 

[360duster]

lookin serious....i like it.

truck block? is it an R-block or what? should be with that bore size....

Keep us updated how it runs!

Michael

 

[superbeesrt8]

Yes R3

 

[nm9stheham]

Got any padding for that cage around your head and shoulders/left leg? Looks nice; welds look pretty decent from this range.

 

[360duster]

i like the W9 Heads.....the headers are custom made? I do not know if there are W9 headers available to fit in to the Chassis.

Wish you luck that all is going well!

Michael

 

[replicaracer43]

Killer!

 

[superbeesrt8]

No the headers are custom made and I have not installed the padding on the roll bar