Deep sump Pan

[RustyRatRod]

Why the epoxy?

 

[RustyRatRod]

Yall that are doin this to the pan....what are you doin for extendin the pickup?

 

[805moparkid]

Why the epoxy?

on the out side... epoxy primer... is hard as nails and will fit very nicely with the flat black color...

i should be getting to the pick up next week, cut a 1/2 i.d. tube to size and splice it into your stock pick up...

 

[Shaker223]

Yall that are doin this to the pan....what are you doin for extendin the pickup?

Cutting the pickup and welding in the correct length mild steel tube.

 

[/6 Matt]

When your done, I want a pan! =P~

 

[805moparkid]

When your done, I want a pan! =P~

your pan should be the same as mine... see what number is on the bottom of it...

 

[805moparkid]

left the oil pan full of water to find leaks and found two pin holes... so moved the lead around and an letting it sit over nite... if no leaks i can blast it, mud it and paint it!

then time for pick up tube

 

[805moparkid]

so i made up the front and rear baffles... installed the rear 1.5" over the lip of the pan...

im not sure how far to go on the rear?? how much it to far??

thx ed

 

[805moparkid]

more updates!

made the pick up, welded in the baffles, blasted and glassed the low spots...

 

[6pakattack]

Moving right along !!!So when does the assembly line start ?? I'd be interested in one !!! I do have a new oil pump pick up,just haven't found a pan yuet !! If you're serious about doing them, I'm serious about buying one !!!:cheers::cheers:

 

[805moparkid]

Moving right along !!!So when does the assembly line start ?? I'd be interested in one !!! I do have a new oil pump pick up,just haven't found a pan yuet !! If you're serious about doing them, I'm serious about buying one !!!:cheers::cheers:

once i finish it up we can talk about doing one!

 

[6pakattack]

Kool Beans !!!

 

[805moparkid]

Kool Beans !!!

haha cool beans....

 

[805moparkid]

ok so finished the filler work, DA'ed it all out, then got it epoxy primed! pan is done!!

so went ahead and studded the block for the pan

 

[6pakattack]

Lookin good !!!! I've eyed up the pan stud kits on Ebay,and that's the route I want to go with too !!:cheers:

 

[805moparkid]

Lookin good !!!! I've eyed up the pan stud kits on Ebay,and that's the route I want to go with too !!:cheers:

i just got mine from copper state...

motor is close to being done!

 

[6pakattack]

Lookin Good !!!That pan looks nice on there !!!

 

[805moparkid]

Lookin Good !!!That pan looks nice on there !!!

yea i just hope it dosn't sit to low below the k member... cont remember how it sits in there...

 

[6pakattack]

That's why we have Torsion bars .Just bump it up a little higher !!Gonna end up doing that with mine so I can get my fatt retired azz into the car easier !!!

 

[805moparkid]

That's why we have Torsion bars .Just bump it up a little higher !!Gonna end up doing that with mine so I can get my fatt retired azz into the car easier !!!

haha yea probably have to... or just put the bumpers back in the LCA haha