Does anybody make these?

[kdbunn]

1967 Dart GT trunk molding clip. The moldings that go above and below the trunk finish panel. As you can see the stud is offset from center. I can't seem to find them anywhere and mine are junk.

 

[Professor Fate]

The '68-'69 ones should work.
Clip Kit Rear Finish Panel 68-69 Dart GT

 

[kdbunn]

Thanks. I looked at those but the 68-69 panel is one complete unit while the 67 is smaller with separate moldings above and below it so it doesn't work. One year only conundrum.

 

[mopar head]

Might find something through these guys.
Welcome to Restoration Specialties - A first class restoration depends on quality products

 

[kdbunn]

Thanks. Had a look. They have very little in the way of 67 dart parts and definitely no molding clip. Sigh.....

 

[jeff alder]

Post a want ad if you can't get a bite it looks like it could be duplicated...small machine shop or fab shop...Check with Hemissdart he might have something like that. Also year one makes a 67 gt dart finish panel clip with a stud that closely resembles that photo. I just saw it upon doing an image search for 1967 gt dart finish panel clips

 

[kdbunn]

Thanks. Those are the clips for the finish panel. Not the moldings that go above and below the finish panel. I will post a wanted ad. I thought someone would make them but I'm guessing there isn't a huge demand for them. I think a lot of guys replace the panel and molding with the one piece 68-69 panel.

 

[mopowers]

Thanks. Had a look. They have very little in the way of 67 dart parts and definitely no molding clip. Sigh.....

You may want to try calling them. They have quite a few items that isn't listed it their catalog. I've gotten lucky before calling them. Good luck!

 

[Mike69cuda]

I have seen folks pop rivet the old clips or other ones to the inside lip of trim panels. Seems to work good and you can’t see it after it’s assembled.

 

[mopar head]

What you have, and the rest are in similar condition, doesn`t look too bad, I`d media blast and paint, and reuse them.

 

[kdbunn]

Lol. That's the best one. Most were rusted beyond use or broken. Believe me, I have been using up brain cells trying to figure a way to get this to work. I'm almost out of them now.

 

[mopar head]

Lol. That's the best one. Most were rusted beyond use or broken. Believe me, I have been using up brain cells trying to figure a way to get this to work. I'm almost out of them now.

They would be actually be a simple clip to fab up, if you have the equipment. good luck