Door Hinge Rebuild

[jhdeval]

I am looking for a door hinge rebuild kit for my 65 barracuda. I found this on summit does it look right?

http://www.summitracing.com/parts/RNB-38381/Application/?query=Make|PLYMOUTH

 

[bigtom]

It looks just like what I used to do mine....

 

[cudaute]

I just didmy driver door the short pin looks to short I recognize the shiny one 2 pins for each door Ibadan to team the bottom holes cause the originals weren't sleeved closes real nice and quiet now fixed the sag old pins were way worn I think I got the set from laysons

 

[cudaute]

I just did my driver door the short pin looks to short I dont recognize the shiny one 2 pins for each door I
Had to ream the bottom holes cause the originals weren't sleeved closes real nice and quiet now. fixed the sag, old pins were way worn I think I got the set from laysons guess I should proof read 1st

 

[res1vw21]

DONT DO IT! using the bushings on the lower hinge can/will cause them to prematurely stress and crack. It also only does half the job, you need to fix the detent and spring too.

Take a look here http://www.forabodiesonly.com/mopar/showthread.php?p=1256402#post1256402

 

[jhdeval]

res1vw1 I found your thread yesterday I just don't the money to pay someone else to do my work right now. I by no means take the shortcuts though. As far as I am concerned if it does not look stock or fairly original I am not doing it.

I realize you get paid to rebuild the door hinges but can you give any hints or suggestions on ways it can be done properly?