Drive Shaft

[dmoore]

Need an original un-modified drive shaft for a 72 340 Duster 727 Auto....need not have the joints installed since it will be rebuilt & balanced...Thanks!

 

[69DARTS]

how long

 

[physixx]

Same question.

 

[73SwingerBuild]

What rear end? That will affect which what length driveshaft you need.

Post the length needed (Measured U-joint center to U-joint center) and I'm sure one of us has one.

 

[dmoore]

Sorry, 45" center to center of caps & it's for an 8 3/4

 

[73SwingerBuild]

I believe my extra one is 48"-49", but I will check for you.

 

[SGBARRACUDA]

I'm sure I have one, I'll look tomorrow.

 

[dmoore]

Thanks, I appreciate that!

 

[SGBARRACUDA]

Thanks, I appreciate that!

Ok the one I checked was from a 68 Barracuda w/ 8 3/4 but it measures 46 1/4 center to center of the u-joints. I have a bunch of drive shafts in a storage trailer but i can't get to them to measure till next week. Let me know if you don't find one and I'll go to the trailer and check.

 

[dmoore]

I will wait for word..........thanks!

 

[TrailBeast]

Would you be better off to have one built for it?
I was quoted $200 for a new built.

Just a thought, because of original price plus shipping.

 

[69DARTS]

http://www.forabodiesonly.com/mopar/showthread.php?t=194175
heres a brand new 1 will this work guys great to deal with

 

[limelite70]

I believe my extra one is 48"-49", but I will check for you.

49 is from a 4 speed car.

 

[dmoore]

Would you be better off to have one built for it?
I was quoted $200 for a new built.

Just a thought, because of original price plus shipping.

I am replacing one a friend gave me a while back and it is going in a correct restored car so it needs to be original....

 

[dmoore]

http://www.forabodiesonly.com/mopar/showthread.php?t=194175
heres a brand new 1 will this work guys great to deal with

That one was straight without the taper at each end......