driveshaft 47-1/2" w/7260 u-joints

[seymour_scamp]

from 72 scamp with 727 & 8-1/4 rear. took this out as I needed a longer one for the 4 spd swap. Very clean & It is 3-1/4" dia & about 47-1/2" ctr to ctr of u-joints. It has been shortened in its life before, but as you can see it has excellent weld. front u-joint is missing one snap ring as i lost it when i took it off. no slip yoke.

$80 plus shipping from 47274 parcel post to USA. I plan on just shrink wrapping it and taping it up to ship.

 

[Sedanman]

Do you know what size you need? I may have it

 

[seymour_scamp]

i have a 50-1/2" that should work, i"ll remember you in case if it happens to be too short I think 51-1/2 would be ideal. Thanks

 

[Sedanman]

The 1 I have is from a 74 dart with 904 & 8 1/4 rear

 

[seymour_scamp]

$70 obo

 

[seymour_scamp]

Still have this one and a 50-1/2" one also
$50 ea plus shipping

 

[txstang84]

Do you know if either of them would fit a 904/8.75 combo?

 

[seymour_scamp]

I would hate to say without knowing the exact measurements needed. The 50-1/2" was an inch too short for my scamp (111" wb car) with an A833 & 8-1/4. The 47-1/2" fit the scamp when it had 727 & 8-1/4.

If at all possible, I would suggest getting the engine/tranny in and then measuring. This way you know exactly what you need, and can see if you can find something used before paying $$ to have one made. Or search the internet for guys that have posted what length is needed and trust they are correct.

 

[WilderDave73]

Do u still have the 471/2 driveshaft?

 

[70aarcuda]

3 1/2 years later.........

 

[6pk2goDemon]

Do u still have the 471/2 driveshaft?

Send the seller a Private Message as they haven't been on FABO in many months.