[WANTED] Early a 8.25 rear length drive shaft

[BJDEALER]

I recently put this rear end in. my 66 cuda. I would like to find a shaft that has already been cut to the right length. I live in a rural area so...

 

[SGBARRACUDA]

Well if you had a measurement I might have one?

 

[BJDEALER]

Where does the measurement need to be taken from exactly?

 

[2manymopars]

center to center of U joint caps. I have one out of a 65 cuda with a 904 with 8.25 rear end. I will be home in a week and can get you a measurement and pic's.

 

[SGBARRACUDA]

center to center of U joint caps. I have one out of a 65 cuda with a 904 with 8.25 rear end. I will be home in a week and can get you a measurement and pic's.

True but you have to position the slip yoke in the trans in the right location before you measure.

 

[whitepunkonnitro]

The shaft you need is 52.5 inches long. 1/4 inch in either direction will work.

 

[BJDEALER]

can I use the shaft out of the 74 dart swinger donar car? My mechanic says the diameter is too wide.