Early A-Body 8 3/4 Driveshaft to 904 Trans

[65Valiant310]

Anyone have an Early A-Body 8 3/4 Driveshaft, which would go to a 904 trans?
I have a fairly new one on the car, and would rather not cut it when I swap in my 8 3/4 in my 65 valiant
thanks!

 

[pettybludart]

When I put the 360/904 and 8 3/4 in my 66 Dart,I used a driveshaft from a 73 Dart 318/904.It was a direct bolt in.Good luck.

 

[jeffneal66]

I have a 904 tranny and drive shaft from my '68 Barracuda which mates to a 8 3/4 I'm selling. Let me know if you are interested. Shipping would be from Bend, OR 97702.

Jeff

 

[65 Dartman]

Anyone have an Early A-Body 8 3/4 Driveshaft, which would go to a 904 trans?
I have a fairly new one on the car, and would rather not cut it when I swap in my 8 3/4 in my 65 valiant
thanks!

Since you have a 65, I suspect you have a flanged 904 that takes the ball and trunnion style of driveshaft. If so, that type for the 8.75 will be hard to find. You might be better off shortening your current driveshaft. If you have a slip joint, much easier to find.

 

[65Valiant310]

Driveshaft was updated to non ball and trunion when engine was swapped to a 318/904 combo.

 

[Commando66]

The Dodges have a longer wheel base than Plymouth. Just something to think about.

 

[65Valiant310]

so the later a-bodies do not have a longer wheelbase?