[WANTED] Early A Fuel Filler Vent Tube

[Jim Kueneman]

I think they should all be about the same (other than maybe Barracuda) but Dart and Valiant should be close enough from '63 to '66. Goes from the nipple in the filler tube over to to the lip between the inner and outer wheel well then pokes though the rubber floor seal show here. Anyone have one they would part with? There is also a clip that clips it on the lip that I could use as well.

 

[RAT ROD AL]

Jim , I have this one, pulled it out of a 65 Barracuda . Look like what you need ? Only pic I have of it.

 

[Jim Kueneman]

Jim , I have this one, pulled it out of a 65 Barracuda . Look like what you need ? Only pic I have of it.
View attachment 1715889865

Looks close enough... how much?

 

[RAT ROD AL]

Have the whole deal listed for $25. I can send you the vent tube for the cost of shipping and if it works for you good deal !

 

[Jim Kueneman]

Have the whole deal listed for $25. I can send you the vent tube for the cost of shipping and if it works for you good deal !

PM sent... Thanks!

 

[RAT ROD AL]

That rusty chrome sleeve held the tube to the fill pipe. you need it to ?

 

[Jim Kueneman]

That rusty chrome sleeve held the tube to the fill pipe. you need it to ?

Mmmmm that may be the difference with a Barracuda! Or the '63 Dart was missing that piece. Sure why not.

 

[RAT ROD AL]

Maybe it'll clean up some ! I'll send it too.

 

[cudamark]

There are different ones depending on the model.....they're bent different. The Barracuda ones won't fit the convertibles due to the different support brace that the convertibles use. Looks like you don't have that brace on your car, so, you should be safe. Worse case, you may have to re-bend it a bit. Mopar only sold those vent tubes new, as a roll that you had to cut and bend yourself.