[SOLD] early z bar/torque shaft

[snate66]

Looking for the 63-66 v8 clutch torque shaft for my small block with the original 9.5 bell housing.
OR any info, drawings, dimensions that show the differences in the above requested item and the 67 and later units for both v8 and slant six.

 

[65 Dartman]

I will have to look but may have an extra torque shaft.

 

[vitamindart]

I have the bellhousing, z bar, pedals and I think a couple rods even.
have a flywheel too but its pretty rough.

 

[snate66]

The three items I am missing from this setup that came out of a 66 4 speed barracuda are the torque shaft( obviously), the 12- 3/4 inch clutch pedal rod and the frame side z bar bracket.
I could have swore I had the whole set up and can see them in my minds eye.. but after 15 years, two house moves and a divorce... im lucky to have retained what I have.

 

[2manymopars]

I have the bracket, rod and z bar.