ENGINE CENTRELINE OFFSET

[brewil]

Hi,

Does anybody know the A-body centreline offset (down the crank and trans tunnel). I was told its 2" but want to verify this.


Thanks in advance

B

 

[rklein383]

found this: Hard to read but says 1.25 inches.

 

[Daves69]

……….
Footnote #39

 

[brewil]

……….
Footnote #39

Much appreciated!!!
Mines a Hemi 265 but it seems crank centre is crank centre.

Thanks!

 

[brewil]

found this: Hard to read but says 1.25 inches. View attachment 1715440729

I think that's for a 66 A-body it seems. Thanks mate

 

[Lefty71]

I though there was some info about this on TTI's website.... like they tell you to double check and give a link when you are purchasing headers, but anyone can go look.

***EDIT*** Footnote #39

 

[Lefty71]

……….
Footnote #39

Whoa!! youre way ahead of me!

 

[Oldiron440]

I've found it easy to measure at the transmission...

 

[pishta]

as long as pinion and trans output shaft are on the same axis, there is not an issue if your fabricating something.